LED Tube T8 150cm 24W high efficiency 140 LM/W
OPAL 150cm 24W Opal, SMD 2835, 230V-AC, angle 330º.
Power factor : 0.95
High efficiency 140 LM/W
| Cool white | Neutral white | Warm white |
| 24W | 24W | 22W |
| 6000K | 4000K | 3000K |
| 3455 lm | 2917lm | 2200 lm |
Detailed Description
LED T8 150cm 24W 140 LM/W high power factor.
Replaces conventional 150cm / 58W fluorescent tubes.
T8 LED tube, equipped with high brightness SMD 2835 chip and high light transmittance (over 90%) glass and plastic coating, allows uniform light distribution.
- Wide AC input range from 175V to 265V
- High power factor up to 0.95
- Wide opening angle (330º)
- Glare-free opal coating
- Short-circuit and overheat protection
- Including starter jumper
- Diameter Ø26mm
Equivalences:
- LED tube T8 150cm 22W Warm white 3000K equivalent to T8 150cm fluorescent 58W/830
- LED tube T8 150cm 24W Neutral white 4000K equivalent to T8 150cm fluorescent 58W/840 - 58W/845
- LED Tube T8 150cm 24W Cool White 6000K equivalent to T8 150cm fluorescent 58W/860 - 58W/865

Download the step by step installation guide from this link.
Installation in ferromagnetic ballasts:
Step 1: Turn off the light at the main switchboard and verify that no electric current is coming.
Step 2: Remove the old tube and then the starter.
Step 3: Put the new LED starter bridge (included with each tube).
Step 4: Remove the capacitor or capacitor (to avoid overvoltage).
Step 5: Install the new LED tube.
Installation in electronic ballasts:
Step 1: Turn off the light at the main electrical panel and verify that no electric current is coming.
Step 2: Remove the old tube (in this case there is no starter, as it is incorporated inside the electronic ballast).
Step 3: Disconnect the cables that enter the electronic ballast (no need to remove it, just disconnect it electrically).
Step 4: Choose one of the 2 tube holders to connect its 2 wires directly to the mains.
Step 5: We recommend to mark the lamp holder where the connection has been made to facilitate the installation of the LED tube.
- If the installation contains a capacitor bank consult your specialized technician.
Applications:
- General lighting, direct replacement of conventional 150cm fluorescent tubes.
- Perfect for illuminating closed parking lots, offices, stores, commercial galleries, kitchens, etc.
- Thanks to its angle, it is ideal for placement on walls.

LED Tube T8 150cm 24W high efficiency 140 LM/W








