Surface-mounted emergency light with 150 lumens and 3h autonomy

The surface-mounted LED emergency light includes a red pilot light labeled "CHARGE". When the red light is on, it indicates that the lamp is charging and the power supply is functioning correctly. In the event of a power outage, the red light will turn off, and the lamp will illuminate.

In accordance with current regulations, it incorporates a "TEST" button on its front. The lamp activates instantly after the power supply is interrupted, without flickering or heating up.

Technical specifications:

✔ Built-in battery: Li-ion 1300 mAh
✔ Voltage: 230V/AC
✔ Approximate battery life: 3 hours on a full charge.
✔ Luminous flux: 150 lumens
✔ IP20

Instructions for use:

✔ Before installation, disconnect the power supply.
✔ Do not install this product in an outdoor door environment, humid and with corrosive gases.
✔ Use only one circuit, do not connect it with other lights, to ensure normal emergency recharging.
✔ Regularly check that the operating conditions are correct.
✔ When stored long-term or out of service, check the light status every three months to maintain battery performance.

Facility:

The emergency light should be installed as follows:

✔ Open the product (turn the bottom part)
✔ Use the fixing screw to secure the lower housing to the wall.
✔ Pass the AC cable through the hole in the lower housing and connect the main circuit board to the L and N terminals.
✔ Close the diffuser.
✔ Connect to AC power.