LED Strip 12V-DC 36W 10mm multicolor RGB IP20 (SMD505050 30ch/m) 5 meters Roll
LED Strip 12V-DC 36W (150 SMD5050), 5m coil, IP20, 120º angle, RGB, Cut every 10cm
-
36W 12V LED Strip
-
5m reel
-
30 chips/meter SMD5050
-
Cutting distance 100mm
-
Protection degree IP20
-
PCB width: 10mm
-
3M self-adhesive
-
Flexible, high brightness and luminosity
-
Requires power supply (not included)
The LED strip is an element that integrates into your projects with minimal visual impact, creating indirect and diffuse lighting that highlights architectural elements.
SMD5050 LED strips are low power and low consumption. Average consumption is estimated at 7.2 W/m. They can be cut every 100mm, allowing them to be adapted and spliced according to the needs of each project.
Installation:
The LED strip comes supplied with 3M self-adhesive tape on the back. Place it on a smooth, non-porous surface and make sure to clean it beforehand. As a flexible strip, it can be used in tight bends. Mounting against the power supply can be done using connectors or by soldering the cable directly to the power supply.
For a complete LED strip installation you will need an RGB controller, a power supply and, optionally, aluminum profiles (surface or recessed). It is estimated that for 12V LED strips, if you want to make stretches longer than 5 meters, you will need to install additional power supplies and signal amplifiers, to avoid voltage drops.
Recommended uses:
-
Highlighting architectural contours.
-
Lighting under furniture and shelves, showcases, showcases
-
Aisles, shop windows, with indirect illumination.
ROHS
Questions
No customer questions for the moment.