LED Tube T8 60cm 9W – High efficiency, uniform light and low consumption

Designed to replace 60cm fluorescent tubes, this T8 LED tube offers an efficient and long-lasting lighting solution, with a 140lm/W output and a 330° beam angle.

• Available in warm white (3000K), neutral (4000K) and cool white (6000K).
  
  
• High brightness SMD 2835 chip.
  
  
• Opal glass and plastic coating: over 90% light transmission.
  
  
• Glare-free and with short-circuit and overheat protection.
  
  
• Compatible with ferromagnetic and electronic ballasts (bridge included).
  
  
• Extended lifespan and maintenance savings.
  
  
• Applications: Perfect for offices, hallways, shops, kitchens or closed parking lots.

Installation in Ferromagnetic reactors:

Step 1: Turn off the light at the main electrical panel and check that there is no electrical current.

Step 2: Remove the old tube and then the primer.

Step 3: Install the new LED starter bridge (included with each tube).

Step 4: Remove the capacitor (to avoid overvoltages).

Step 5: Install the new LED tube.

Installation in Electronic Ballasts:

Step 1: Turn off the light at the main electrical panel and check that there is no electrical current.

Step 2: Remove the old tube (in this case there is no primer, since it is incorporated into the electronic ballast).

Step 3: Disconnect the cables entering the electronic ballast (there is no need to remove it, just disconnect it electrically).

Step 4: Choose one of the 2 pipe holders to connect your 2 cables directly to the electrical network.

Step 5: We recommend marking the lamp holder where the connection has been made to facilitate the installation of the LED tube .